Mosites reusable vacuum blankets

Silicon rubber compounds are available in rolls up to 72" (1.83m) in a variety of thicknesses.

Mosites #14324 - Translucent

This compound is based on a platinum cure system that gives excellent elongation and tear-resistance.

• 40 Shore A hardness
• 11.0 MPa tensile strength
• 1100 % elongation
• translucent color

Mosites #14116 - Soft

Mosites #14116-E is a 30 durometer, high strength, high elongation silicone compound for use as a reusable vacuum blanket in forming composite aerospace articles. It is available in cured or uncured sheet form in all standard thicknesses and in widths of up to 72 inches.

• 30 Shore A hardness
• 8.9 MPa tensile strength
• 900 % elongation
• gray color

Mosites #14284 - Thermally Conductive

This blue compound is used where greater durometer and thermal conductive properties are required.

• 62 Shore A hardness
• 3.4 MPa tensile strength
• 310 % elongation
• 0.74 W/mK thermal conductivity (BTU 5.12 in/h/ft2/°F)
• light blue color

Mosites #14206 - Silicon Adhesive Tape

This compound is a 65 Durometer, high strength, uncured silicone rubber compound for use as an adhesive tape for bonding cured and uncured silicone sheet to metal or composites surfaces and also for bonding cured silicone sheet or extrusion to itself

• 65 Shore A hardness
• 6.9 MPa tensile strength
• 350 % elongation
• gray color

3" (76.2mm) wide Mosites 14206 uncured repair tape

Fluoroelastomer Rubber Compounds are available up to 48" width (1.22m) in a variety of thicknesses.

Mosites #2902 - High Temperature "Aflas®"

This high temperature resistant fluorelastomer compound has excellent resistance to acids, bases, high pH corrosion inhibitors, sour gas and oil, high pressure steam and alcohols.

• 75 Shore A hardness
• 17.9 MPa tensile strength
• 201 % elongation
• black color

Mosites #2902 is not recommended for service in chlorinated solvents, Freon refrigerant, and tetrahydrofurane solvent.

Mosites #1028 - Viton® Sponge Sheet

This is a closed cell Viton® sponge formulation that is manufactured with a continuous skin on both sides. The skin makes the sheet stronger and more tear resistant and even when the surface skin is punctured or cut, the sheets will not allow the passage of air or fluid between cells. The non-absorbent sheets are highly compressible, resilient, lightweight and provide good thermal insulation.

• -20 to +200 °C service temperature
• thicknesses: 1/8", 1/4", 3/8", 1/2"
• (3.18, 6.35, 9.52, 12.70 mm)